Kama Bay 35-2000; ohm
4 partecipanti
T-Forum, la vera HiFi alla portata di tutti :: Amplificatori :: Integrati e finali a stato solido in classe T/D :: Altri chip in classe T/D
Pagina 1 di 1
Re: Kama Bay 35-2000; ohm
Allora, per quanti avessero lo stesso dubbio in futuro e dovessero finire su questo thread, segnalo che ho interpellato direttamente la Scythe; mi hanno risposto di cercare solo diffusori a 8 ohm, in quanto con gli altri ci potrebbero essere danneggiamenti; riporto il testo integrale della risposta:
"I recommend you to buy 8 Ohm speakers. I would say there is a very good chance that it will work properly, but there is also a small chance that the speakers / amp will be damaged. The speakers are 4 ohms so it will give the amp higher stress than 8 ohms speakers as you need double the power to drive a 4 ohms Compared to an 8 ohms speakers. It might make the amp halt at half volume or earlier. I cannot be clear since some speakers goes as low as 2 ohms although they are rated 4. This is because they rate the speakers on average impedance, but impedance is not always the same value from the point of frequency. As in a 200Hz signal to the speaker may be 4 ohms, but a 80Hz signal to the speaker could be 2 ohms. This depends on the speaker’s characteristics called impedance curve. The halt of the amp itself will not damage the gears, but when an Amplifier is in stress, there is a chance that the amplifier will output Distorted signals that may damage the amp and / or the speakers. The chances are low but there still is.
__________________
English & German Support"
CLipper
"I recommend you to buy 8 Ohm speakers. I would say there is a very good chance that it will work properly, but there is also a small chance that the speakers / amp will be damaged. The speakers are 4 ohms so it will give the amp higher stress than 8 ohms speakers as you need double the power to drive a 4 ohms Compared to an 8 ohms speakers. It might make the amp halt at half volume or earlier. I cannot be clear since some speakers goes as low as 2 ohms although they are rated 4. This is because they rate the speakers on average impedance, but impedance is not always the same value from the point of frequency. As in a 200Hz signal to the speaker may be 4 ohms, but a 80Hz signal to the speaker could be 2 ohms. This depends on the speaker’s characteristics called impedance curve. The halt of the amp itself will not damage the gears, but when an Amplifier is in stress, there is a chance that the amplifier will output Distorted signals that may damage the amp and / or the speakers. The chances are low but there still is.
__________________
English & German Support"
CLipper
clipper- Appassionato
- Data d'iscrizione : 10.03.11
Numero di messaggi : 265
Località : Parma
Provincia : parma
Impianto : Sintoampli Marantz + Casse Bose - Scythe Kama Bay 35-2000 + Scythe Kro Craft - Cuffie: Sennheiser HD569, Superlux HD681 evo, Superlux HD668b, Sennheiser PX100, KZ ED16, Sennheiser CX300, Tennmak Dulcimer, Liam & Daan Swan - Dap: iBasso DX150, Cayin N3, Ruizu A50, Sansa Clip+.
Re: Kama Bay 35-2000; ohm
In pratica alla Scythe hanno letto la risposta che ti aveva dato emmeci e l'hanno tradotta in inglese!!
Zio- Membro classe argento
- Data d'iscrizione : 06.04.13
Numero di messaggi : 3955
Provincia : Emilia
Impianto : Sorgente, amplificazione, casse, un po' come tutti...
Re: Kama Bay 35-2000; ohm
CLipper
clipper- Appassionato
- Data d'iscrizione : 10.03.11
Numero di messaggi : 265
Località : Parma
Provincia : parma
Impianto : Sintoampli Marantz + Casse Bose - Scythe Kama Bay 35-2000 + Scythe Kro Craft - Cuffie: Sennheiser HD569, Superlux HD681 evo, Superlux HD668b, Sennheiser PX100, KZ ED16, Sennheiser CX300, Tennmak Dulcimer, Liam & Daan Swan - Dap: iBasso DX150, Cayin N3, Ruizu A50, Sansa Clip+.
Argomenti simili
» fischio kama bay 2000
» Scythe Kama Bay SDAR-2000
» Impedenza ScyThe Kama Bay AMP 2000
» Scelta diffusori per Scythe Kama Bay Amp 2000
» Sansui AU117 vs Scythe Kama Bay 2000
» Scythe Kama Bay SDAR-2000
» Impedenza ScyThe Kama Bay AMP 2000
» Scelta diffusori per Scythe Kama Bay Amp 2000
» Sansui AU117 vs Scythe Kama Bay 2000
T-Forum, la vera HiFi alla portata di tutti :: Amplificatori :: Integrati e finali a stato solido in classe T/D :: Altri chip in classe T/D
Pagina 1 di 1
Permessi in questa sezione del forum:
Non puoi rispondere agli argomenti in questo forum.
|
|
Oggi alle 9:55 Da giucam61
» Consiglio amplificatore vintage
Oggi alle 9:29 Da giucam61
» Testina "anonima"
Oggi alle 8:36 Da RF14381
» AUX-IN rotto, si può bypassare?
Oggi alle 4:52 Da Gionni
» problema amplificatore kenwood ka-56
Oggi alle 3:07 Da valterneri
» Modern Jazz Quartet
Oggi alle 0:07 Da arthur dent
» Problema giradischi Philips f7114
Ieri alle 23:19 Da bertuc79
» Consiglio su cavi di potenza
Ieri alle 21:08 Da lello64
» youtube a brevi scatti
Ieri alle 17:25 Da lello64
» L'(auto)inganno sul loudness
Ieri alle 2:55 Da Francesco Toscana
» Che musica ascoltate in questo momento?
Mar 26 Mar 2024 - 20:12 Da TRIPLALLOSCADERE
» Lorenzo Naccarato Trio
Mar 26 Mar 2024 - 17:51 Da Francesco Toscana
» ABBINAMENTO PRE E FINALE IMPEDENZA CORRETTA?
Mar 26 Mar 2024 - 17:25 Da genodave
» rumore di fono o 50 hertz
Mar 26 Mar 2024 - 15:50 Da GAMBACORTA STEFANO
» Preamplificatore Xindac 3200mkIi
Mar 26 Mar 2024 - 1:55 Da morpheus2023
» Consiglio amplificatore Dynamics gsa8500
Lun 25 Mar 2024 - 21:25 Da Codo
» Bowers & Wilkins 705 S3 oppure 706 S3 per MARANTZ PM8006
Lun 25 Mar 2024 - 19:39 Da giucam61
» Amplificatori diversi che suonano più simili di quanto ricordavo
Lun 25 Mar 2024 - 16:44 Da arthur dent
» Problema velocità su vecchio giradischi Pioneer PL300
Lun 25 Mar 2024 - 15:59 Da maxilconte
» pre phono SUPA 2.0
Lun 25 Mar 2024 - 13:50 Da goggo20
» Consiglio su come terminare i cavi del braccio giradischi
Lun 25 Mar 2024 - 13:16 Da valterneri
» Vendo marantz pm-84 II - 350€
Lun 25 Mar 2024 - 11:26 Da woolfgar
» migliori sw e codec per mettere cd-audio sul pc
Dom 24 Mar 2024 - 19:00 Da hernandezhk47
» Lettore mp3 e flac-ape portatile
Dom 24 Mar 2024 - 18:38 Da Jaguarx
» Niente di nuovo sul fronte D?
Dom 24 Mar 2024 - 15:36 Da arthur dent
» temperatura HITACHI HA-8700
Dom 24 Mar 2024 - 15:22 Da GAMBACORTA STEFANO
» Diffusori a sospensione pneumatica
Dom 24 Mar 2024 - 13:32 Da giucam61
» Aiuto su Giradischi "stretto" da inserire in libreria
Ven 22 Mar 2024 - 10:38 Da RadioAut
» TPA 3116 D2 Forte rumore all'accensione poi nulla
Ven 22 Mar 2024 - 8:57 Da embty2002
» SACD e ascolto dsd nativo
Mer 20 Mar 2024 - 22:49 Da genodave